Had a very simple goal today. 1. Remove Engine 2. Begin fabrication of tunnel. Time allocated: Task 1 - 10 mins, task 2, rest of morning. Oh that it were so simple! Began by positioning hoist to support engine so that once the mounts were undone, the chassis could be lifted a few cms to clear them before manoeuvering it clear past the exhaust stub, which will be going soon! However, for some reason, the engine didn't come out level and the right engine mount remained not only firmly attached, but also skewed so that no motion either wasy was possible. 2 hours of fruitless effort followed during which time I was unable to budge anything. At least the integrity of the welding was proven as the entire engine/gearbox were suspended from one mount while I 'tapped' it to free it. Unfortunately I caught a glancing blow on a couple of pieces loosly tacked in place, which fell off! Eventually I was forced to admit defeat as the mount had begun to bend. I had to cut it off the chassis. Time was then up for the day so I returned home for lunch a very unhappy bunny! Maybe tomorrow when I have chilled a bit I will start task 2 on my list!
Reminder to self: Supposed to be enjoying this!!!!
No comments:
Post a Comment